Color

Thickness/Weight

Width

Length

Characteristics

3d decorative panel

Wall sticker

3d velvet decorative panel

Floor stickers

Self-adhesive decorative mirrors

Self-adhesive foils

Decorative Wall Sticker

Easily and economically change the look of the wall in the room or part of it. It has a good application and a realistic effect.&nbsp;

Specifications:

<ul>
	<li>Material: PVC</li>
	<li>Dimensions: 60cm x 300cm</li>
	<li>Washable</li>
</ul>

It is self-adhesive and can be applied to any smooth and flat surface.

The large thickness recommends this sticker model for application on walls and ceilings. It is important that these surfaces are smooth, clean, without embossed patterns.

&nbsp;

&nbsp;

The first and perhaps the most important step in ordering a wallpaper model is measuring the wall. We recommend adding 10 cm to each height for more effectiveness and safety.

For an ordinary wall, the process should be simple and intuitive: measure the length and height of the wall separately and note the respective elevations. Avoid including decorative elements such as plinths, battens, or other such accessories in the measurements. Check the measurements. 
With an inclined wall, it is important to start with the longer or wider side, with increased attention to any kind of irregularity or unevenness of the wall. The wallpaper roll has a rectangular shape, which means that during assembly it can be cut or cut according to the respective shape and specifications. 
If you have an irregular wall&nbsp;or one that frames elements such as a window, door, or something similar, we recommend measuring the total dimensions of the wall. During installation, all these elements will be cut from the wallpaper roll.

 
Important! For any measurements, we recommend adding 10 cm to avoid any error or imperfection of the wall!

Carefully prepare the surface on which the wallpaper is to be glued. It must be clean, neat, and non-absorbent. If you want to apply it on a new screed or plasterboard, apply a primer based on an race first. The mounting surface must be white.

The wallpaper strips are cut taking care of the continuity of the model, numbering them on the back with a pencil (no pen is used), then the strip is glued following the vertical or the previously glued strip. Prepare the adhesive according to the type of wallpaper. Mix the contents with water until a homogeneous paste is obtained. Mix vigorously again after 5 minutes. With a stencil or a brush, apply an even layer on the wall, or, as the case may be, on the wallpaper roll. Always follow the instructions for use of the wallpaper manufacturer. Immediately clean the excess adhesive with a damp cloth.

It is pressed with a rubber roller or squeegee, taking care not to leave air bubbles under the wallpaper, after which immediately wipe off the excess adhesive from the joints. Do not rub the joints hard! When it is wet, the wallpaper is more sensitive and can be damaged very easily.

If you have purchased a paintable vinyl wallpaper, allow at least 24 hours to pass between gluing the wallpaper and applying the first layer of paint. The paint must be water-based.

High-quality wallpaper can create a pleasant and welcoming interior. In order to prolong the life of the wallpaper, it must be vacuumed and wiped, if necessary, with a damp cloth, soaked in an ecological solution, without additives.

Measuring the wall

Preparing the wall

Installation of wallpaper

Recommendation

3D decorative sticker with geometric design, metallic gray, 60cm x 300cm

MallDeco

SuperPrice – Marks a product whose price is competitive compared to relevant online offers. Valid from DD.MM.YYYY to DD.MM.YYYY.

Calculate how many wallpaper rolls you need

To any measurement, we recommend adding 10 cm to avoid any error or imperfection of the wall!

Enter dimensions and options

according to the dimensions you entered, and the price below is for the number of rolls needed for the indicated area.

We deliver the products directly to your door

Free shipping for orders over 16000 eur. Guaranteed return within 14 days

 Please notify me when it's back in stock

Share your opinion by giving a rating to the product.

Other customers have also seen the displayed products

By sending the request, you agree with the

By publishing the review, you agree with the

3D decorative sticker with geometric design, metallic gray, 60cm x 300cm

Products from the same collection

Recommended products